Multi valve Swimming PoolNorth Cyprus Forums Homepage Join Cyprus44 Board | Already a member? Login
Popular Posts - List of popular topics discussed on our board.
You must be a member and logged in, to post replies and new topics.
Tatty

Joined: 24/09/2008 Posts: 186
Message Posted: 11/10/2009 07:49 | Join or Login to Reply | Message 1 of 4 in Discussion |
| On the multi valve there is a setting for curculation i never here anybody refer to this setting.what is it used for? |
Navek


Joined: 01/06/2008 Posts: 2656
Message Posted: 11/10/2009 11:10 | Join or Login to Reply | Message 2 of 4 in Discussion |
| Hi Tatty, Normally I will use it after I have backwashed and rinsed the filter. It can be used when you want to mix chemicals into the pool water quickly, chlorine etc, as I think the pump will run a bit faster, no resistance. After a few hours it can then be put back to the filter position. Sorry, but I don't know what else it could be used for :-( Never operate the Multivalve when it's running, switched on!!! Here's a link that may be helpful.... http://www.waterwayplastics.com/manuals/810-0066.1108.pdf Good luck, Navek |
Tatty

Joined: 24/09/2008 Posts: 186
Message Posted: 11/10/2009 11:14 | Join or Login to Reply | Message 3 of 4 in Discussion |
| Navek Thanks for the info. Tatty |
TRNCVaughan

Joined: 27/04/2008 Posts: 4578
Message Posted: 11/10/2009 14:27 | Join or Login to Reply | Message 4 of 4 in Discussion |
| Circulation takes the filter out of service while leaving the pump runnable. In this position you can take the top off the filter with the pump running to change the sand, for example. |
North Cyprus Forums Homepage
Join Cyprus44 Forums | Already a member? Login
You must be a member and logged in, to post replies and new topics.
|